Designed by Sparkman & Stephens . . . proudly built by Yankee Yachts
This STANDARD equipment makes the YANKEE 30 the finest 30 value afloat!
One piece 100% hand lay-up fiberglass hull with molded-in contrasting boot-top. One piece 100% hand lay-up fiberglass deck with molded-in non-skid. Complete headliner. Complete hull liner. 8 portlights --- 7 fixed, 1 opening clamp-down watertight type with screen, in head. Large dinette with formica table, teak trim--- letting down to form 51 berth, 64 long. Complete galley with two ice chests (P & S), sink, separate 22-gal. water tank, compartment for stove and oven. Settee berth and convertible upper berth opposite dinette, 64 long. Two 68 berths in forward compartment --- plus large chain locker with louvered teak doors. Enclosed head installation with sink, storage drawers and mirror, separate 10-gal water tank. Expanded vinyl interior cushions. Atomic Four gasoline inboard engine installation with blower. Flexible fuel lines and filters. Two Lewmar #25-C 2 speed geared sheet winches, 1 handle. One Lewmar #8 Haylard winch. 1 handle. Teak toerail and trim encircle entire boat. Two teak cabin top handrails. Yankee custom elliptical mast --- 6061-T6 alloy, keel stepped. Boom --- Round aluminum 6061-T6 with track. Equipped with Mariner clew outhaul, 4:1 purchase. Internal boom lift. Stainless steel standing rigging --- 7/32 head and backstays, ¼ upper shrouds, 9/32 lower shrouds, all with toggles. Headstay with special toggle aloft --- Backstay with adjustable turnbuckle handles --- 5/32 midstay with quick release. Special masthead with provision for internal halyards, 4 large aluminum sheaves with special bearings, offset spinnaker halyard crane. Running rigging --- stainless steel main and jib halyards with dacron rope tails. Dacron main and jib sheets. Electrical --- Cabin, running and masthead lights. Fused panel with 7 switches. Valves on all underwater thru-hull fittings --- quick throw valves on head. Oak tiller. Teak companionway drop slides. Fiberglass companionway hatch cover --- teak trimmed. Stern chocks and cleats. 15 by 29 custom Yankee stemhead fitting with Avdel pin, two bow chocks and 7 bow cleat. Sheet winch islands with cleats and handle holder compartments. Tow 7 halyard cleats on mast. Four ball-bearing mainsheet clocks. Mariner Whiz-bang mainsheet traveller track and car with taglines and 7 Schaefer fiddle block and cam cleat. Twenty feet of genoa track --- Merriman 1 extruded aluminum T track with Lewmar rollertype genoa fairleading genoa sheets to winches. Yankee custom bow pulpit with port and starboard running lights mounted for visibility while sailing with genoa.
NOTE: Equipment shown in pictures in brochure is typical, but not necessarily standard. Check specifications and standard equipment and options list. Prices and Specifications Subject to Change without notice.
YANKEE YACHTS
7724 SOUTH GRAND AVENUE
SANTA ANA, CALFORNIA 92705 * Phone
(714) 557-9955